• PSS Shaft Seal - For 20mm to 60mm Shafts
  • PSS Shaft Seal - For 20mm to 60mm Shafts
  • PSS Shaft Seal - For 20mm to 60mm Shafts
  • PSS Shaft Seal - For 20mm to 60mm Shafts

PSS Shaft Seal - For 20mm to 60mm Shafts


Brand: PSS


  • PSS Shaft Seals is...

    A mechanical face seal that is created between the flat surfaces of the rotating stainless steel rotor and the stationary carbon flange. The stationary carbon flange is attached to the vessels stern tube with hose clamps and the carbon flange is attached to the front side of the bellows with hose clamps. The stainless steel rotor is fit on the shaft in front of the carbon flange. The stainless steel rotor is used to compress the bellows before the collar is secured to the shaft with set-screws. This compression (pre-load) maintains contact between the faces and allows the PSS to compensate for the thrust from the propeller. The carbon flange is bored larger than the shaft diameter allowing it to “float” around the shaft and thus compensate for most misalignment and vibration problems. The stainless steel collar is sealed to the shaft by two o-rings that are recessed into the bore of the collar. These o-rings rotate with the shaft and stainless steel rotor and do not experience wear during operation.

    • ABS Certified
    • RINA Certified
    • Bureau Veritas Certified

    For more information on the PSS Shaft Seal please visit www.shaftseal.com.

    Maintenance

    As with any rubber hose below waterline, the PSS bellows must be inspected on a regular basis for any sign of wear, aging or chemical deterioration. PYI suggests preventative maintenance. The PSS bellow should be replaced in six year intervals. During bellows replacement it is recommended the o-rings & set screws in the stainless steel rotor also be replaced.

    NEVER USE SET SCREWS MORE THAN ONCE!
  • How To Install The PSS Shaft Seal

Customer Reviews

Based on 1 review Write a review