Part Number: 07-034K
A stainless steel rotor that is slid down the shaft and secured with set screws at 90 degrees for maximum holding power. Precision tolerances are maintained by computer controlled lathes. The faces have a number 9 micro finish and are perpendicular to the bore to prevent run-out as the collar rotates. The Carbon Stator will polish the face of the rotor during the first few minutes of operation. The stainless steel rotor should not need to be replaced under normal operating conditions. The stainless steel rotor used on the PSS Shaft Seal are made from 316L stainless steel.
Thanks for the quick shipment. Rotor and new bellows installed all good..
Photo submission deadline of 9/15/2019.